Seats – Raising the stock seat 2.5″ or 64mm

Raising the stock seat 51mm to 64mm (2 inches to 2.5 inches)

part A)..Home Depot: Model #800284/ SKU #368989 / spacer 5/16″ (8mm) x 1/4″ (6mm) / two for $5.07 USD / dimensions: spacer is 1/4″ (6 mm) long, hole is 5/16″ (8 mm)

part B)..Amazon – Sentry Supply 650-6419 U-Bracket, 1-Inch, Chrome https://www.amazon.com/dp/B00DUQ9ZB6/ref=cm_sw_r_apan_i_FNXBX8BHKXYZVNP16GZM?_encoding=UTF8&psc=1 … hole is 17/64 inch or 7 mm

step 1).. Drill top and bottom holes of U bracket out to about 10 mm or 3/8 inch

Installation order: gas tank bolt, part B U bracket, part A spacer, original washer.

For step 2, you will need a 7/16″ or 8 mm Allen wrench

step 2) Put the gas tank bolt into the “U” bracket. The gas tank bolt should face down and the open part of the “U” should face the back of the bike.

step 3) Add part A Spacer and the original washer onto gas tank bolt and install.

step 4) When the tank bolt is tight, (optional) bend the top part of the “U” bracket so the gap is 11 mm or 7/16″. It makes it easier to have a board that is 11 mm so you can use that to check the gap. The open gap should face the REAR of the motorcycle.
REAR BOLTS – Replace the stock M6 x 22mm bolts with two bolts M6 x 73mm (2″ lift) or M6 x 86mm (2.5″ lift)
REAR BOLTS – You also need two spacers – M6 x 73mm (2″ lift) NEED 51MM SPACER or M6 x 86mm (2.5″ lift) NEED 64MM SPACER